• 1-20mm Joint Widths
• Kitchens, Bathrooms, Swimming Pools, Power Showers, etc.
• Water Repellent
• Polymer Modified
• Internal & External
• Anti-Fungal
• Mould Resistant

Specially developed for areas where movement or vibration is likely. Ideal externally

and internally in both wet and dry conditions, including swimming pools and power

showers. Suitable for most common tile applications including natural stone, porcelain,

conglomerate and ceramic wall and floor tiles

TECHNICAL DATA

Packaging: Triple walled paper bags.

Standard Conformity: Conforms to the requirements of EN13888

Class: CG2.

Drying Time: 10-15 minutes dependent on temperature.

Pot Life: 60 minutes dependent on temperature.

Set Time: 24 hours.

Application Thickness: 1-20mm.

Protein Free: Yes.

Colours: Limestone.

Sizes: 5kg.

Storage: Store in unopened original bags at

conditions between 5°C and 25°C. Avoid

frost. This product must be stored clear of

the ground in cool, dry conditions and

protected from excessive drafts. If stored

correctly and used within 6 months of the

date shown on the bag, the activity of the

reducing agent will be maintained and this

product will contain, when mixed with water,

no more than 0.0002% (2ppm) soluble

Chromium (IV) of the total dry weight of the

cement. Note: The use of this product after

the end of the declared storage period may

increase the risk of an allergic reaction.

Shelf Life in Unopened Bags: 6 months in cool, dry conditions above 5°C

and below 25°C.

INFORMATION

Ultra Flex Joint Grout has been specially designed for areas where movement or

vibration is likely. With excellent joint filling capacity, the product allows for joints

up to 20mm to be grouted in one application. Polymer has been added to the

formulation to increase flexibility and to provide a virtually impermeable set.

Ultra Flex Joint Grout is suitable for use with most common tile applications

including natural stone, porcelain, conglomerate and ceramic wall and floor tiles.

PRECAUTION

Certain tiles may suffer from discoloration or scratching when using grouts. We

would recommend that a test application be carried out prior to grouting.

SURFACE PREPARATION

Ensure that the adhesive is completely set and that the tiles are firmly fixed.

Ensure that joints are free from excess adhesive, dust, grease or any other

contaminates.

MIXING

Ultra Flex Joint Grout powder should be added slowly to clean water in a

suitable container in the approximate proportion of 3.5 parts powder to 1 part

water. Mix until a smooth consistency is achieved. Do not mix more than can be

used in a 45-60 minute period, do not re-wet or add too much water. This will

cause a weakening of the grout and a tendency to crumble. In certain cases this

may also lead to discoloration in the form of efflorescence. Mixing ratio: 1kg of

product to 0.2 litres of water.

APPLICATION

Ultra Flex Joint Grout should be applied to the surface using a rubber backed

trowel or squeegee. Work the mixed material thoroughly into the joints, a small

area at a time. Ensure that the joints are completely filled without voids before

continuing. Excess grout should be removed as grouting proceeds. Any residue

left on the face of the tile can be removed by wiping with a damp sponge

when the grout has started to dry (approximately 10-15 min). Any dry film

remaining once the job is complete can be polished off the face of the tiles with

a soft dry cloth.